護坡磚的施工步驟如下：

　　The construction steps for slope protection bricks are as follows:

　　地面準備：首先，需要清理施工區域，確保地面平整、干燥，并清除任何雜物和障礙物。如果有需要，可以進行土方開挖和壓實，以確保地基牢固。

　　Ground preparation: Firstly, it is necessary to clean the construction area, ensure that the ground is flat, dry, and remove any debris and obstacles. If necessary, earthwork excavation and compaction can be carried out to ensure a solid foundation.

　　布置標線：使用標尺和粉筆線，在地面上布置出需要安裝護坡磚的輪廓線，并確保輪廓線的直線度和水平度。

　　Layout marking: Use a ruler and chalk line to lay out the contour line on the ground where slope protection bricks need to be installed, and ensure the straightness and levelness of the contour line.

　　按規格切割護坡磚：根據需要，使用合適的磚切割工具，按照所需尺寸將護坡磚進行切割。

　　Cutting slope protection bricks according to specifications: Use appropriate brick cutting tools as needed to cut the slope protection bricks according to the required size.

　　涂抹膠漿：將水泥砂漿或專用粘結劑涂抹在地面上，形成一層厚度適當的膠漿層。可以使用抹刀或者批刀進行均勻涂抹。

　　Applying adhesive: Apply cement mortar or specialized adhesive to the ground to form a layer of adhesive with appropriate thickness. You can use a spatula or spatula to apply evenly.

　　開始鋪設磚塊：將切割好的護坡磚逐個放置在膠漿上，按照預定輪廓線的順序鋪設。注意保持磚與磚之間的間距均勻，同時也要保持磚與地面之間的貼合度。

　　Start laying bricks: Place the cut slope protection bricks one by one on the mortar and lay them in the order of the predetermined contour line. Pay attention to maintaining a uniform spacing between bricks, while also maintaining the fit between bricks and the ground.

　　敲實護坡磚：使用橡膠錘等工具，輕輕敲擊每個護坡磚，使其與膠漿和地面緊密接觸，并確保整體平整、穩固。

　　Knock down the slope protection bricks: Use tools such as rubber hammers to gently tap each slope protection brick to make it closely contact with the adhesive and the ground, and ensure the overall flatness and stability.

　　清理和修整：在鋪設完畢后，使用濕布清除磚面上的漿料殘余物，并進行必要的修整，使護坡磚表面整潔、平整。

　　Cleaning and trimming: After laying, use a damp cloth to remove any residue of mortar on the brick surface, and make necessary trimming to make the surface of the slope protection brick clean and flat.

　　固定邊緣：根據需要，在護坡磚的邊緣處設置垂直的邊界線條或邊石，以增強護坡磚的固定性和美觀度。

　　Fixed edge: Set vertical boundary lines or curbstones at the edge of the slope protection brick as needed to enhance its fixation and aesthetics.

　　養護：根據具體材料要求，對新鋪設的護坡磚進行適當的養護，例如用濕布覆蓋并保持濕潤，防止過早干燥和開裂。

　　Maintenance: According to specific material requirements, appropriate maintenance should be carried out on newly laid slope protection bricks, such as covering them with a damp cloth and keeping them moist to prevent premature drying and cracking.